Pride Mobility IFMANU2121 A R E a N D M a I N T E N a N C E, Care and Maintenance, Temperature

V . C A R E A N D M A I N T E N A N C E

CARE AND MAINTENANCE

Your Stylus requires routine maintenance checks. You can perform some of these checks, but others require assis- tance from your authorized Pride Provider. Preventive maintenance is very important. If you follow the mainte- nance checks in this section as scheduled, you can help ensure that your wheelchair gives you years of trouble-free operation. If you have any doubt as to your wheelchair’s care or operation, contact your authorized Pride Provider.

WARNING! Do not service the wheelchair when the seat is occupied.

Your wheelchair is susceptible to damage from the elements. Avoid damp areas of any kind.

WARNING! Direct or prolonged exposure to water or dampness could cause the wheelchair to malfunction mechanically. Water can cause the chair’s frame to rust. Wheelchairs should be examined periodically for signs of corrosion caused by water exposure, bodily fluids exposure, or incontinence. Damaged components should be replaced or treated immediately.

Should your wheelchair come in contact with water:

1.Dry your wheelchair as thoroughly as possible with a towel.

2.Allow your wheelchair to sit in a warm, dry place for 12 hours to allow unseen water to evaporate.

3.If any inconsistencies are found, take your wheelchair to your authorized Pride Provider. Wheelchairs that are frequently exposed to sources of water, such as incontinence, should be inspected often for corrosion.

Temperature

Some of the parts of your wheelchair are susceptible to extreme changes in temperature. Always keep your wheel- chair between the temperatures of 18° F (-8° C) and 122° F (50° C).

General Guidelines

„Avoid prolonged exposure of your wheelchair to extreme conditions, such as heat, cold, or moisture.

„Make sure pneumatic tires are inflated to the psi/bar/kPa air pressure rating indicated on the tire.

WARNING! Make sure your tires are inflated to the psi/bar/kPa air pressure raiting indicated on the tire for pneumatic tires. Do not underinflate or overinflate your tires. Low pressure may result in loss of control, and overinflated tires may burst. Overinflating tires can cause them to explode.

WARNING! Do not use a high pressure hose to inflate your tires.

„Use a rubber conditioner on the tire sidewalls to help preserve them.

WARNING! Never use a rubber conditioner on the tread area of the tires; doing so may make the tires slippery and cause your wheelchair to skid.

„All wheel bearings are prelubricated and sealed. They require no subsequent lubrication.

Daily Checks

„Check for loose or missing screws, nuts, and bolts. Replace or tighten them as necessary.

„Check the tires. Look for uneven wear, holes, or tire/rim separation. If they look excessively worn, then have them replaced.

„Visually inspect pneumatic tires for punctures.

„Confirm correct air pressure as marked on the side of the tire.

„Check for flat spots on solid tires. Flat spots could adversely affect stability.

„Check the handrims. Make sure that they are fastened securely to the wheels.

„Check the manual wheel locks. Make sure they work properly. If they do not, instructions on how to adjust them are provided in this manual.

Stylus www.pridemobility.com 23