Pride Mobility INFINFB2046 VSI Diagnostic Flash Codes # of Leds Cause Possible Solution

BASIC TROUBLESHOOTING INSTRUCTIONS: JET 7

What if my Jet 7 begins pulling to one side?

!Determine if the joystick is being deflected straight or at a slight angle. Even a small amount of deflection right or left will cause the chair to veer over a long distance.

!Determine if both manual freewheel levers are in the drive position. If only one manual freewheel lever is in the drive position, the other motor will not operate and the Jet 7 will veer severely.

!Determine if both tires are inflated to the proper psi if the power chair is equipped with pneumatic tires. Pneumatic tires should be inflated to 35 psi (2.4 bar). If one tire is inflated more than the other, the power chair will pull to the side that is underinflated.

!Determine if the caster wheels are pivoting freely. If either caster wheel is not pivoting freely, the unit will veer to the side.

What if the Jet 7 powers up, but will not move?

!Determine if both manual freewheel levers are in the freewheel position. If the power chair is in freewheel mode, then the electronics will function but the motors will not spin the wheels.

!Determine if the controller is flashing a fault code. The Jet 7 comes equipped with a VSI controller. The VSI controller will flash a code via the battery condition meter LEDs if a system fault is detected.

VSI DIAGNOSTIC FLASH CODES

# OF LEDS	CODE	CAUSE	POSSIBLE SOLUTION
One red LED	1	Low battery voltage	Charge batteries
Two red LEDs	2	Left motor open	Make sure left motor is plugged into controller.
Three red LEDs	3	Left motor wiring fault	Contact your authorized Pride Provider.
Three red LEDs	4	Right motor open	Make sure right motor is plugged into controller.
One yellow LED
Three red LEDs	5	Right motor wiring fault	Contact your authorized Pride Provider.
Two yellow LEDs
Three red LEDs	6	Inhibit active	Contact your authorized Pride Provider.
Three yellow LEDs
Three red LEDs	7	Joystick error	Contact your authorized Pride Provider.
Four yellow LEDs
Three red LEDs	8	Controller error	Contact your authorized Pride Provider.
Four yellow LEDs
One green LED
Three red LEDs	9	Brake fault	Make sure both motors are plugged into controller.
Four yellow LEDs
Two green LEDs
Three red LEDs	10	High battery voltage	Contact your authorized Pride Provider.
Four yellow LEDs
Three green LEDs

INFINFB2046/Rev A/11-29-06 www.pridemobility.com 2