Pride Mobility Jazzy Select Series manual Controller Position, Armrest Width Adjustment

	V . C O M F O R T A D J U S T M E N T S
Controller Position
You can move the controller in toward or out away from the
armrest, or change the position the controller for either left-
hand or right-hand use.
	WARNING! Do not place the controller
	and charger cables so that they can be
	pinched in the seat frame or the power
	base frame.
To extend the controller:		ARMREST
1.	Flip up the armrest so it is perpendicular to the floor.
		KNOBS
2.	Loosen the setscrew on the controller bracket. See
	figure 13.
3.	Slide the controller into or out of the armrest to the de-
	sired position.
To change the controller position:
1.	Unplug the controller and charger connectors from the	Figure 12. Armrest Width Adjustment
	power base.
2.	Cut the wire tie(s) securing the controller and charger
	cable s to the armrest.
3.	Flip up the armrest and loosen the setscrew. See figure 13.
4.	Slide the controller out of the armrest.
5.	Loosen the setscrew in the other armrest.
6.	Place the controller in the other armrest.	SETSCREW
7.	Tighten the setscrew to secure the controller.
8.	Use a wire tie to secure the controller and charger cables

to the armrest.

9.Plug the controller and charger connectors into the power base.

Armrest Width Adjustment	JAM NUT
Youcanchangeeacharmrest’swidthindependentlyoftheother.	ARMREST
	ANGLE
NOTE: Changing the armrest width may increase the	ADJUSTMENT
	SCREW
overall width of your power chair.
To change the armrest width:	ARMREST
1. Locate the two armrest knobs on each side of the
	HEIGHT
armrest receiver bracket. See figure 12.
	ADJUSTMENT
2. Loosen the knobs.	SETSCREWS

3.Slide the armrests in or out to the desired width.

4.Tighten the knobs.

Figure 13. Armrest Angle and Height Adjustment

Select Traveller www.pridemobility.com 25