V I . C O M F O R T A D J U S T M E N T S

To adjust the ELR length:

1.Remove the two leg rest adjustment screws from the side of each leg rest extension. See figure 20.

2.Loosen the bolt on the side of each leg rest extension.

3.Slide the leg rest in or out to the desired length.

4.Tighten the bolt and reinstall the two screws on each leg rest extension.

ANTI-TIP WHEELS

The anti-tip wheels are designed to give your Jet 2 increased stability on rough surfaces. The anti-tip wheels are preset at the factory to a height of 1/2 in. off the ground. This setting is for smooth surfaces or for indoor use only. If you plan on using your Jet 2 on rough surfaces, it may be necessary to adjust the anti-tip wheels to better suit your needs.

The anti-tip wheels may need adjustment if either of the fol- lowing occur:

νWhen coming to a stop, your Jet 2 tips forward excessively.

νThe anti-tip wheels constantly rub the ground.

Required Tool: 13 mm wrench

NOTE: Each drive tire must have at least 30 lbs. of air pressure in order for the anti-tip wheels to be properly ad- justed.

WARNING! Consult your authorized Pride pro- vider before attempting to change the anti-tip wheel height! Changing the anti-tip wheel height affects handling under deceleration.

To adjust the anti-tip wheels:

1.Remove the seat and body shroud.

2.Adjust the 13 mm anti-tip adjustment nut so that the anti-tip wheel is 1/2 to 1 inch off the ground. Turn the nut clockwise to raise the anti-tip wheel and counter- clockwise to lower the anti-tip wheel. See figure 21.

WARNING! The higher you raise the anti-tip wheels, the more you increase your power chair’s tendency to tilt forward when coming to a stop. You can compensate for this by hav- ing your authorized Pride provider make a small adjustment to the pre-programmed de- celeration setting in the controller or by mov- ing the seat assembly further to the rear of your power chair.

Figure 19. Elevating Leg Rests

RELEASE LEVER

LEG REST

ADJUSTMENTBOLT

Figure 20. Elevating Leg Rests

LEG REST ADJUSTMENT SCREWS

ANTI-TIPADJUSTMENTNUT

Figure 21. Anti-tip Adjustment

Jet 2/Rev F/Feb03

www.pridemobility.com

25

Page 25
Image 25
Pride Mobility JET2 To adjust the ELR length, ANTI-TIP Wheels, Required Tool 13 mm wrench To adjust the anti-tip wheels