34 Rally Shopper
XI. CARE AND MAINTENANCE
The following areas require periodic inspection and/or care and maintenance.
TIRE CONDITION AND TREAD WEAR
nRegularly inspect your scooters tires for signs of wear.
nUse a rubber conditioner on your scooters tires to help to preserve them.
WARNING! Do not put rubber conditioner on tire tread; this may cause the tires to become
dangerously slippery.
EXTERIOR SURFACES
nBumpers and trim also benefit from an occasional application of rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooters vinyl seat; it may
become dangerously slippery.
nThe tiller shroud, front shroud, and the rear shroud are formed from durable ABS plastic and coated with an
advanced formula urethane paint.
nA light application of car wax will help the shrouds retain their high gloss.
BATTERY TERMINAL CONNECTIONS
nMake certain that the terminal connections remain tight and uncorroded.
nThe batteries must sit flat in the battery wells.
nThe battery terminals should face the rear of the scooter.
WIRING HARNESSES
nRegularly check all wiring connections.
nRegularly check all wiring insulation, including the charger power cord, for wear or damage.
nHave your authorized Pride provider repair or replace any damaged connector, connection, or insulation that
you find before using your scooter again.
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
nThese items are all prelubricated, sealed, and require no subsequent lubrication.
CONSOLE, CHARGER, AND ELECTRONIC CONTROLLER ASSEMBLY
nKeep these areas free of moisture.
nIf any of these items do become exposed to moisture, let them dry thoroughly before operating the scooter
again.