INTENDED USE
This toaster is designed to toast breads bagels or English muffins.Do not attempt to toast croissants. Their butter content will cause them to stick to the conveyor. Do not attempt to toast products that have been buttered or spread with jam or other coating. Do not attempt to bake in the toaster.
7.The toaster fan located on the bottom of the toaster in the rear draws in cool room air and circulates it through the toaster sides and tops. To insure adequate heat dissipation do not posi- tion the toaster where the fan would draw in hot discharge from another appliance.
OPERATION
1. Plug unit into the proper voltage receptacle.
INSTALLATION
1.After you have removed the toaster from the carton, inspect the unit for signs of damage. If there is damage to the unit:
λNotify carrier within 24 hours after delivery.
λSave carton and packing materials for inspection purposes.
λContact your local dealer or, if purchased di- rectly, the Prince Castle Customer Sales Depart- ment at
2.Verify that all parts have been received. Remove Protective Coating.
3.Attach four (4) legs to toaster by screwing in each leg clockwise.
4.Adjust legs so toaster is level.
5.Remove packaging from bun slide and install bun slide in toaster by hooking it into the two pins in the rear of the chamber. (See Detail 1)
6.Attach heat shield by hooking its top tabs onto the two mounting pins just under the crumb tray then allow the shield to swing down so it touches the two lower mounting pins. Lift shield slightly to hook onto the lower pins. Attach the product slide tray by hooking its tabs onto the two uppper mounting pins at the top front of the toaster. (See Detail 2)
2. Set Power switch to “l” for On.
3.Turn upper and lower heater controls to maxi- mum.
4.Allow 20 minutes for toaster to warm up.
5.Lay Bread, Bagel or Muffin, cut side up on the inlet ramp and push into toaster until it slides on to the conveyor chain. To control toast color, vary the conveyor speed or the heater settings.
PREVENTIVE MAINTENANCE
1.The toaster is cooled using air flowing through the electrical areas. DO NOT operate the toaster without either side cover or the rear cover.
2.The conveyor chain should not touch the top surface of the crumb tray holder. If the chain does touch, retension it by unplugging the unit, remove both side covers, loosen the front bearing mounting screws and pivot the bearing until the chain no longer touches.
3.The toaster has an internal high temperature switch. If internal temperature becomes too hot the switch will shut off power to the top heaters. The switch will reset automatically once the
2toaster has cooled.
