Profile 100SX installation instructions High Level Connections Optional

HIGH LEVEL CONNECTIONS (OPTIONAL)

If a low level RCA signal source is not available, you may still wire the models 100SX, 200SX, and 400SX with high-level or speaker level outputs from your head unit. However, only speaker leads from a "floating ground" system may be used (see diagram below). Use the strip connector located on the end of the amplifier to make this connection. The strip connector should be connected with the front or rear, 2 channels of your head unit.

Note: The speaker leads from a "common ground" head unit systems should not be connected to the hi-level input terminals of the following connections.

CAUTION! Before making any connections determine the type of radio to avoid possible damage to amplifier and/or radio.

HI - LEVEL INPUT					X-OVER	BASS
	INPUT	LEVEL	FILTER			BOOST
L+ L- R + R -
	LEFT
			LOW		HI
				OFF
		MIN MAX			40Hz 130Hz	0dB 12dB

RIGHT

94.7

RIGHT -

RIGHT +

LEFT -

LEFT +

TWO CHANNEL CONNECTIONS:

FLOATING GROUND RADIO (MOST COMMON TYPE)

8