5.Turn the Console (88)
Hold the ends of the Pulse Bar (110) against the Console Frame (7) as shown. Connect the pulse wire in the Console (88) to the pulse wire in the Pulse Bar (see the inset drawing). The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one con- nector and try again to connect them. Attach the Pulse Bar to the Console Frame with the four Pulse Bar Screws
(68).Firmly tighten the Pulse Bar Screws. Be careful not to damage the wires.
Attach the ring on the ground wire to the Console Frame
(7)with a 1/2” Ground Screw (114). Note: There are no wires on the other side of the Pulse Bar (110).
6.Attach the Console Back (95) to the console assembly with five 3/4” Screws (6).
7.With the help of another person, hold the console as- sembly near the Right Upright (82) and the left Upright (not shown).
Connect the Wire Harness (83) to the wire harness in the console assembly. Make sure to connect the con- nectors properly (see the inset drawing); the con- nectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try to connect them again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAM- AGED WHEN THE POWER IS TURNED ON. Insert the excess wire harness back into the right handrail.
Set the console assembly on the Right Upright (82) and the Left Upright (not shown). Thread two 1/4” x 1” Bolts (71) with 1/4” Star Washers (92) into each side of the console assembly. After you have started all four
Bolts, tighten them.
5 |
|
|
110 | 68 | 114 |
| ||
88 |
| 7 |
Pulse |
|
|
Wire |
|
|
Ground |
|
|
Wire |
|
|
Pulse |
|
|
Wire |
|
|
6 | Console Assembly | |
| ||
|
| 6 |
6 | 95 | 6 |
|
| |
7 |
|
|
Console |
| |
Assembly |
| |
| 83 |
|
Right Handrail |
| |
|
| 92 |
83 | 71 | |
| ||
|
| 82 |
8
