ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dis- pose of the packing materials until assembly is completed. Assembly requires the included allen wrench

and your own phillips screwdriver , adjustable wrench , and scissors .

1.With the help of a second person, carefully raise the treadmill to the upright position. While a second person tips the treadmill to one side slightly and holds it, insert one of the Extension Legs (59) into the Base (32) as shown. Make sure that the Extension Leg is turned so the bracket is on top. Using the Allen Wrench (102), tighten an Extension Leg Screws (57) into the Base and the Extension Leg. Next, tip the treadmill to the other side and attach the other Extension Leg in the same way.

With the help of a second person, carefully lower the treadmill so that both Extension Legs (59) are resting flat on the floor.

2.Refer to HOW TO LOWER THE TREADMILL FOR USE on page 11. Follow the instructions in step 2 to lower the treadmill.

Without removing the tape from the Latch (34), hold the Latch against the left Upright (32) as shown. Attach the Latch to the left Upright with four shorter Screws (33).

Make sure that the Screws are tight, but do not overtighten them; if the Screws are overtightened, the Latch will not slide smoothly. After the Latch is attached, remove any visible tape.

Note: The inset drawing shows how the parts of the Latch (34) fit together.

3.Cut the plastic tie holding the cage nut in the upper end of the Left Handrail (60).

Position the Left Handrail (60) on the left Upright (32) as shown. The bracket on the Extension Leg (59) should be inside of the lower end of the Left Handrail. Thread a Handrail Bolt (30) with a Handrail Washer (31) into the left Upright and the Left Handrail. Do not tighten the

Handrail Bolt yet.

1

 

 

32

 

59

102

 

 

57

 

Bracket

 

 

2

 

 

32

 

 

34

 

Spacer

 

 

33

 

Springs

 

 

33

 

Latch

 

 

 

 

Bracket

3

 

 

30

 

 

 

31

60

 

 

32

 

 

59

 

 

5

Page 5
Image 5
ProForm 625EX user manual Assembly, Handrail Bolt yet