13.Raise the Frame (56) to the position shown.
Have a second person hold the Frame until this step is completed.
Orient the Storage Latch (53) so that the large barrel and the Latch Knob (54) are in the posi- tions shown. Attach the lower end of the Storage Latch to the bracket on the Base (83) with a 3/8" x 2" Bolt (4) and a 3/8" Nut (8).
Attach the upper end of the Storage Latch (53) to the bracket on the Frame (56) with a 3/8" x 2" Bolt (4) and a 3/8" Nut (8). Note: It may be nec- essary to move the Frame back and forth to align the Storage Latch with the bracket.
Lower the Frame (56) (see HOW TO LOWER THE TREADMILL FOR USE on page 20).
13 | 56 |
| |
8 | 4 |
| |
| 53 |
54 | Large |
| Barrel |
| 83 |
| 8 |
| 4 |
14.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread- mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see pages 22 and 23).
If you purchase the optional chest pulse sensor (see page 18), follow the steps below to install the re- ceiver included with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated #8 x 3/4" Screw (12) and the Access Door (87) from the Console Base (93).
2.Connect the wire on the receiver (A) to the indi- cated wire extending from the Console Base (93). Hold the receiver so the small cylinder is oriented as shown and is facing the Console Base. Attach the receiver to the plastic posts on the Access Door (87) with the two in- cluded small screws.
3.Make sure that no wires are pinched. Reattach the Access Door (87) with the #8 x 3/4" Screw (12). Discard the other wires in- cluded with the receiver.
| 93 | |
Small | Wire | |
Screws | ||
A | ||
| ||
Small |
| |
Cylinder |
| |
| 87 | |
| 12 |
11
