ProForm 485E, 831.285736 user manual

3.Find the Left Pedal (31), which has a ridge on the right side. Attach the Left Pedal to one of the Pedal Arms (12) with three M4 x 19mm Round Head Screws (16) as shown.

Repeat this step to attach the Right Pedal to the other Pedal Arm (not shown).

4.Identify the Left Handlebar (8) (there is an ÒLÓ sticker on the Left Handlebar for identification).

Apply a light film of grease to the axles on the Handlebars (8, 62) as shown.

Make sure that there are two Pedal Arm Bushings

(42)in each Pedal Arm (12).

Slide a Handlebar Spacer (39) and the Pedal Arm

(12)with the Left Pedal (31) onto the Left Handlebar

(8)as shown. (Note: These parts fit tightly; it may be helpful to use the rubber mallet). Next, refer to the PART IDENTIFICATION CHART on page 5 and iden- tify the 3/4Ó Axle Caps (43). Tap a 3/4Ó Axle Cap onto the Left Handlebar.

Repeat this step to attach the other Pedal Arm (12) to the Right Handlebar (62).

5.Apply a light film of grease to the axles on the Upright

(3) and the Crank Arms (59) as shown.

Slide a Weld Spacer (49) onto the left axle on the Upright (3). Make sure that the open side of the Weld Spacer is facing the Upright.

Slide a Pedal Arm Spacer (41) onto the left Crank Arm (59).

Make sure that there are two Rear Pedal Arm Bushings (11) in the Pedal Arm (12) attached to the Left Handlebar (8).

With the help of another person, slide the Left Handlebar (8) onto the left axle on the Upright (3) while sliding the left Pedal Arm (12) onto the left Crank Arm (59). Note: These parts fit tightly; it may be helpful to use the rubber mallet. In addition, it may be helpful to rotate the left Crank Arm (59) to a different position.

Tap a 5/8Ó Axle Cap (57) onto the left axle on the Upright (3). Tap a 3/4Ó Axle Cap (43) onto the left Crank Arm (59).

Repeat this step to attach the Right Handlebar and the right Pedal Arm (not shown).

7

3
Ridge
31
12
16
4
62
8
12
39
42
43
Grease
12
31
5
Grease
57
49
8
3	Grease
41	59
11
12
43