STORAGE AND TROUBLE-SHOOTING
Inspect and tighten all parts of the AIR WALKER reg- ularly. Replace any worn parts immediately.
The AIR WALKER can be cleaned with a soft, damp cloth. Keep liquids away from the electronic monitor. Keep the monitor out of direct sunlight or the display may be damaged. Remove the batteries when storing the AIR WALKER.
REPLACING THE BATTERIES
If the display of the electronic monitor becomes dim, or if the monitor does not function properly, the batter- ies should be replaced. To replace the batteries, first lift the monitor from the crossbar cover (see assembly step 4 on page 5). Make sure that the reed switch wire is fully connected to the wire on the monitor. To replace the batteries, refer to assembly step 3 on page 4.
HOW TO FOLD THE AIR WALKER FOR STORAGE
When the AIR WALKER is not in use, it can be folded for storage. To fold the AIR WALKER, first remove the lock knob from the left leg. Next, move to the front of the AIR WALKER and place one foot on the round tube. Firmly grasp the frame with your hands in the locations indicated below. While holding the round tube stationary with your foot, pull the top of the AIR WALKER toward you until the uprights fold against the frame. Place the AIR WALKER in a location where it cannot fall.
Lock | Front |
Knob |
|
Back |
|
| Hand |
| Frame |
Upright | Round |
| Tube |
8
