2.With the help of another person, carefully lower the Uprights (69) as shown. Note: It may be helpful to place one foot on one of the Extension Legs (109, 109) as you tip the Uprights. Make sure that the Extension Legs remain in the Uprights.
Attach the Left and Right Extension Legs (108, 109) with four 1” Tek Screws (39) and two Base Pads (57) as shown. Attach the lower Tek Screw, without the Base
Pad, first.
Attach the other two Base Pads (57) to the base of the Uprights (69) with two 1” Tek Screws (39).
3.Insert the two Wheel Endcaps (65) into the base of the Uprights (69) as shown. Attach the two Wheels (66) with two Wheel Bolts (64) and two Wheel Nuts (32) as shown. Do not overtighten the Wheel Bolts; the Wheels should be able to spin freely.
With the help of another person, carefully raise the Uprights (69) to the vertical position.
4.Identify the Right Handrail (72), which has a large hole in the left side. Feed the Upright Wire (42) into the hole in the bottom of the Right Handrail and out of the large hole in the side. Note: It may be helpful to use needlenose pli- ers to pull the Wire Harness out of the hole.
Attach the Right Handrail (72) to the right Upright (69) with a Handrail Bolt (37).
Attach the Left Handrail (71) as described above. Note: There is not a wire harness on the left side.
7
2 |
|
|
|
|
| 69 |
|
|
|
| 39 |
|
|
| 57 |
| 57 | 39 | 57 |
|
|
| |
|
| 63 |
|
|
|
| 39 |
|
| 108 |
|
69 | 57 |
|
|
| 39 |
| |
|
|
| |
| 109 |
|
|
3 |
| 65 | 66 |
|
|
| |
|
| 32 |
|
|
| 69 |
|
|
|
| 64 |
64 | 66 |
|
|
65 |
|
| |
| 32 |
|
|
4 |
|
71 |
|
37 |
|
42 | Hole |
| |
37 |
|
| Hole |
72 |
|
| 69 |
