ProForm 831.297950 Diagram of the Console, Battery Installation, Step by Step Console Operation

Models: 831.297950

1 18
Download 18 pages 55.87 Kb
Page 8
Image 8

DIAGRAM OF THE CONSOLE

 

 

 

LED Track

 

Monitor Displays

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Speed Control Clip

Key

Note: If there is a thin sheet of clear

plastic on the console, remove it.

 

 

CAUTION: Before operating the console, read the following precautions.

¥Do not stand on the walking belt when turn- ing on the power.

¥Always wear the clip (see the drawing above) while operating the treadmill.

¥Adjust the speed in small increments.

¥To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console, and use only a sealed water bottle.

BATTERY INSTALLATION

The console requires two "AA" batteries (not in- cluded). Alkaline batteries are recommended. To install batteries, open the battery cover as shown below. Press the batteries into the battery compartment, with the negative (Ð) ends of the batteries touching the springs. Close the battery cover, push up on the tab, and then push the tab forward as shown. Be sure that the tab locks into place.

 

Battery Cover

 

Battery

Batteries

Cover Tab

STEP BY STEP CONSOLE OPERATION

Step onto the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothing. Follow the steps below and on page 9 to operate the console.

1Insert the key fully into the power switch.

When the key is in- serted, the first indica- tor in the LED track will

light. The four displays will not turn on until the ON/RESET button is

pressed or the walking

belt is started. Note: If you just installed batteries, the displays will already be on.

2Reset the speed control.

Slide the speed control down to the RESET position. Note: Each time the walking belt is stopped, the speed control must be moved to the RESET position before the walking belt can be restarted.

8

Page 8
Image 8
ProForm 831.297950 Diagram of the Console, Battery Installation, Step by Step Console Operation, Reset the speed control