ProForm DRTL39221 user manual Right Handrail 72 to discharge any static

6.Place the Console Base (47) on the Right Handrail (72) and the Left Handrail (not shown). Attach the Console Base with four 3/4” Screws (2) (only two Screws are shown). Do not overtighten the Screws.

Insert the Wire Harness (42) through the two indicated plastic ties on the Console Base (47). Next, touch the

Right Handrail (72) to discharge any static.

Refer to drawing 6b. Find the 3-wire connector on the end of the Wire Harness (42). Insert the connector into the red socket beneath the Console (43). The connector should slide easily into the socket and “snap” into place. If the connector does not slide easily and snap into place, turn the connector and then insert it.

IMPORTANT: IF THE CONNECTOR IS NOT INSERTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.

Insert the 5-wire connector into the black socket beneath the Console (43) in the same way.

Make sure that the connectors and wires appear as shown at the right.

7.Insert the excess Wire Harness (42) into the large hole in the side of the Right Handrail (72). Securely tighten the plastic ties on the bottom of the Console Base (47) to prevent the Wire Harness from slipping. Then, cut off the ends of the plastic ties.

Route the Wire Harness (42) through the indicated open- ing in the Console Base (47). Attach the Wire Cover (44) to the Console Base with a 1/2” Silver Screw (48).

Tighten two 3/4” Screws (2) into the Console Base (47).

8.Attach a Wheel (66) to the inner side of each Extension Leg (63) with a Wheel Bolt (64) and a Wheel Nut (13) as shown. Do not overtighten the Wheel Bolt. The Wheel should be able to spin freely.

Lift the treadmill frame (see HOW TO FOLD THE TREADMILL FOR STORAGE on page 11), but do not latch it. Make sure that the frame is centered between the Handrails (not shown). Firmly tighten the bolts used in assembly step 4. Then, lower the frame to the floor.

6a	72	47
		42
		Ties
2		43
6b		42
			43
		3-wire	5-wire
		Connector	Connector

7			47
Ties	42	Opening
			44
72
		48	2
8

13 63

66 64

9.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the walking belt (see page 14). To protect the floor or carpet, place a mat under the treadmill.

7