4.Attach each Extension Leg (63) with two 1” Tek Screws (39) and a Thin Base Pad (67) as shown. Attach the lower Tek Screw, without the Thin Base Pad, first.
Attach the two Thick Base Pads (57) to the base of the Uprights (69) with two 1” Tek Screws (39).
Attach the two Wheels (66) with two 2” Bolts (64) and two Wheel Nuts (32) as shown. Do not overtighten the Bolts; the Wheels should be able to spin freely.
With the help of another person, carefully raise the Uprights (69) to the vertical position.
See step 2. Tighten the two Handrail Bolts (37).
5.Hold the Console Base (47) near the Left Handrail (71). Attach the end of the ground wire on the Console Base to the indicated small hole in the Left Handrail with the Silver Ground Screw (75).
6.Touch the Right Handrail (72) to discharge any static. Insert the end of the Upright Wire (42) into the socket in the bottom of the Console Base (47). The connector should slide easily into the socket and snap into place. If the connector does not slide easily and snap into place, turn the connector and then insert it.
4 | 69 | 66 | 64 |
|
|
| 39 |
|
| 32 | 57 |
|
| 67 | |
| 66 |
| |
|
|
| |
64 | 32 |
|
|
| 57 |
| 39 |
| 39 | 63 | |
|
| ||
|
|
| |
| 67 |
|
|
| 39 |
|
|
69 |
|
|
|
63 |
|
|
|
5 |
|
|
|
| Ground |
|
|
| Wire |
|
|
| 47 |
|
|
| Small |
|
|
| Hole |
|
|
| 71 | 75 |
|
|
|
| |
6 |
|
|
|
| 72 |
|
|
|
| 42 | 47 |
8
