ProForm DTL73942 user manual Troubleshooting, PROBLEM The power does not turn on

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department toll- free at 1-888-533-1333, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 8). Use only a single-outlet surge suppressor that meets all of the specifications described on page 8. Important: The treadmill is not compatible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.

c. Check the reset/off circuit breaker located on the treadmill frame near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five min- utes and then press the switch back in.

Tripped Reset

PROBLEM: The power turns off during use

SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console. Reinsert the key fully into the console.

d.If the treadmill still will not run, please call our Customer Service Department.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Remove the key from the console and UNPLUG THE	a
POWER CORD. Next, remove the screws from the hood
	1/8”
and carefully remove the hood. Locate the Reed Switch
	40	11
(17) and the Magnet (12) on the left side of the Pulley (11).
		12
Turn the Pulley until the Magnet is aligned with the Reed	17
Switch. Make sure that the gap between the Magnet
and the Reed Switch is about 1/8”. If necessary, loosen	Top
the indicated Screw (40) and move the Reed Switch	View
slightly. Retighten the Screw. Re-attach the hood and run
the treadmill for a few minutes to check for a correct speed
reading.

23