ProForm PCTL93240 user manual Three Washers 38 as shown. Firmly tighten the indi

2.With the help of another person, carefully lower the Uprights (69) as shown. (Note: It may be helpful to place your foot on one of the Extension Legs [63] as you tip the Uprights.) Make sure that the Extension Legs re- main in the Uprights.

Attach each Extension Leg (63) with two 3/4” Tek Screws (102).

Attach four Base Pads (57) with four 3/4” Tek Screws (102) as shown. Note: One replacement Base Pad may be included. If a Base Pad becomes worn and needs to be replaced, use the replacement Base Pad.

With the help of another person, carefully raise the Uprights (69) to the vertical position.

3.Attach the Storage Latch (29) to the left Upright (69) with two 3/4” Screws (2). Do not overtighten the Screws.

4. Identify the Right Handrail (72), which has a large hole in

the left side. Remove any ties from the bracket on the

Right Handrail and from the Wire Harness (42). Feed the

Wire Harness up into the bracket on the Right Handrail

and out of the large hole in the left side. (Note: It may be

helpful to use needlenose pliers to pull the Wire Harness

out of the large hole.) Press a Handrail Cap (76) onto the

lower end of the Right Handrail as shown.

Insert the bracket on the Right Handrail (72) into the top

of the right Upright (69) so the Handrail Cap (76) is rest-

2
57
102
102	102
		57
57	63
102
	102		69
		57	63
	102
3
	29
	2
	69
4	42

Large

Hole

Bracket

37

38

38

ing against the right Upright. Attach the Right Handrail

and the Handrail Cap with three 3/4” Bolts (37) and

three Washers (38) as shown. Firmly tighten the indi-

72

37

Tighten

cated Bolt, but do not tighten the other Bolts yet.

Attach the Left Handrail (not shown) as described above.

Note: There is not a wire harness on the left side.

7

69

38

37 76