6
2. Attach the Frame Extension (84) to the Frame (1)
with six M10 x 22mm Button Screws (80) and six
M10 Split Washers (54).
Attach the other Stabilizer (19) to the Frame
Extension (84) with two M10 x 75mm Carriage Bolts
(65) and two M10 Nylon Locknuts (64).
3. Attach the Seat (20) to the Seat Post (6) with four
M8 Nylon Locknuts (66) and four M8 Split Washers
(81). Note: The Nylon Locknuts and Split Washers
may be preattached to the Seat.
Turn the Seat Knob (29) counterclockwise two or
three turns to loosen it. Next, pull the Seat Knob,
insert the Seat Post (6) into the Frame (1), and then
release the Seat Knob. Move the Seat Post up and
down slightly until it locks into position.
Push the Seat Guide (46) into the top of the Frame
(1). Secure the Seat Guide to the Frame with an M4
x 4mm Screw (70). Then, tighten the Seat Knob.
3
20
6
1
66
81
46
65
19
64
64
54
80
80
80
54
54
84
1
29
70
4. Apply a small amount of the included grease to the
Handlebar Axle (33). Insert the Handlebar Axle into
the Frame (1) and center it. To avoid damaging
the Reed Switch Wire (31), make sure that it is
positioned as shown in the inset drawing. (Note:
It may be helpful to use a rubber mallet to insert the
Handlebar Axle.)
While another person holds the Upright (2) in the
position shown, connect the Extension Wire (39) to
the Reed Switch Wire (31). Carefully pull the
upper end of the Reed Switch Wire to remove
any slack.
Set the Upright (2) on the Frame (1); be careful not
to pinch the Extension Wire (39) or the Reed
Switch Wire (31).Attach the Upright with three M10
x 17mm Button Screws (55) and three M10 Split
Washers (54).
4
2
39
55
55 54
54
31
1
Grease
33
33
31 Side
Shield
1
2