7
8. Find the Left Pedal (13), which is marked with an “L.”
Attach the Left Pedal to the Left Pedal Arm (11) with
two M8 x 52mm Button Screws (36), two M8 Split
Washers (44), and two M8 Washers (68) as shown.
Attach the Right Pedal to the Right Pedal Arm (not
shown) in the same way.
8
13
11
36
7
2
55
8
6
59
46
46
47
Arrow
47
56
Grease
10. Make sure that all parts of the elliptical trainer are properly tightened. Place a mat under the elliptical
trainerto protect the floor or carpet from damage.
9. Apply a generous amount of grease to the axle on
the left Disc Crossbar (16). Slide the Left Pedal Arm
(11) onto the axle, and attach it with an M10 x 27mm
Button Screw (66) and an M10 Washer (35).
Insert the left Handlebar Arm (5) into the bracket on
the end of the Left Pedal Arm (11), and attach it with
a Pedal Arm Bolt Set (40).
Attach the right Pedal Arm (not shown) in the same
way.
See step 6. Tighten the M8 x 45mm Button Bolts (50)
in the Handlebar Arms (5).
See step 5. Tighten the two M10 x 76mm Button
Bolts (27) in the Upright (2).
11
9
5
66
7. Apply a generous amount of the included grease to the
Pivot Axle (59) and to the two M8.5 Washers (55). Next,
insert the Pivot Axle into the Upright (2) and center it.
Reapply grease to both ends of the Pivot Axle.
Slide a Handlebar Spacer (47) onto the short tube on
each Handlebar (6, 8), and rotate the Handlebar
Spacers so the small arrows are pointing toward the
floor. Next, slide the Handlebars onto the Pivot Axle (59).
Make sure that the Handlebars are on the correct
sides.
Tighten an M8 x 25mm Button Screw (56) with an M8.5
Washer (55) and a Wave Washer (29) into each end of
the Pivot Axle (59). Next, orient the two Handlebar Caps
(46) as shown, and press the small tabs on the
Handlebar Caps into the two Handlebar Spacers (47).
29
Grease
16
35
40
44
44 68
68