ProForm PFTL29020 user manual Diagram of the Console, Battery Installation, AA batteries

DIAGRAM OF THE CONSOLE

Displays

Speed Control

Note: If there is a thin sheet of clear plastic on the face oftheconsole,removeitbeforeoperatingtheconsole.

CAUTION: Before operating the console, read the following precautions.

•Do not stand on the walking belt when turning on the power.

•Always wear the clip (see the drawing below) while using the treadmill. When the key is

removed from the console, the walking belt will stop.

•Adjust the speed in small increments.

•To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console. Put only sealable water bottles in the water bottle holders.

BATTERY INSTALLATION

The console	12
requires two
"AA" batteries
(not included).
Alkaline batter-
ies are recom-	Batteries
mended.	12
To install bat-
teries, open
the battery
cover (12)
beneath the	Tab
console as
shown. Press

two batteries into the console. Make sure that the negative (–) ends of the batteries are touching the springs. Close the battery cover, push up on the tab, and then push the tab forward as shown in the inset drawing. Make sure that the tab locks into place.

STEP-BY-STEP CONSOLE OPERATION

Before operating the console, make sure that the power cord is properly plugged in (see page 8).

Step onto the
foot rails of the
treadmill. Find	Key
the clip attached
to the key, and
slide the clip
onto the waist-
band of your
clothes. Next,	Clip
insert the key
fully into the con-

sole. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed.

9