DIAGRAM OF THE CONSOLE
Speed Control | Monitor Displays | Incline Control |
Key |
Clip |
CAUTION: Before operating the console, read the following precautions.
•Do not stand on the walking belt when turning on the power.
•Always wear the clip (see the drawing above) while using the treadmill. When the key is re- moved from the console, the walking belt will stop.
•Adjust the speed in small increments.
•The training zones marked above the speed control are general guidelines only. See page 14 for more information.
•To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console. Use only a sealable water bottle.
BATTERY INSTALLATION
The console requires two "AA" batteries (not included). Alkaline batteries are recommended.
To install batteries, open the battery cover under the console as shown below. Press two batteries into the
battery com- |
|
partment. |
|
Make sure |
|
that the neg- | Batteries |
ative |
|
of the batter- |
|
ies are |
|
touching the |
|
springs. | Battery |
Close the bat- | Cover |
tery cover. |
|
STEP-BY-STEP CONSOLE OPERATION
If there is a thin sheet of clear plastic on the face of the console, remove it.
Before operating the console, make sure that the power cord is properly plugged in. (See HOW TO PLUG IN THE POWER CORD on page 7.)
Stand on the foot rails of the treadmill. Find the clip at- tached to the key and slide the clip onto the waistband of your clothes. Next, insert the key into the console.
Test the clip by carefully taking a few steps back- ward until the key is pulled from the console. If the key is not pulled from the console, adjust the posi- tion of the clip as needed. Then, remove the key from the console.
8
