5.Set the console assembly on the Handrails (71); insert the excess wiring down into the right Handrail. Attach the console assembly with four 3/4” Screws (2), two Console Bolts (90), and two 1/4” Star Washers (96) as shown.
Make sure that no wires are pinched. Start all four Screws and both Console Bolts before tightening any of them.
6.Attach the Weight Rack (102) to the Uprights (69) with two Rack Screws (101).
7.Attach the Latch Housing (29) to the left Upright (69) with two 3/4” Screws (2). Make sure that the large hole in the Latch Housing is on the side shown. Do not over- tighten the Screws.
Remove the knob from the pin. Make sure that the collar and the spring are on the pin as shown. Then, insert the pin into the Latch Housing (29), and tighten the knob back onto the pin.
Place the Weights (not shown) on the Weight Rack (102).
5 | Console Assembly |
|
|
| |
| 71 | 71 |
| 96 | 2 |
2 | 90 | 96 |
|
| 90 |
6 |
|
|
101 | 69 |
| |
102 | 101 |
7 |
|
| 102 |
69 |
|
29 |
|
Knob |
|
Spring | |
2 | Collar |
| |
| Pin |
8.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place; the large allen wrench is used to adjust the walking belt (see page 20). To protect the floor or carpet, place a mat under the treadmill.
8
