11.Firmly tighten the four 5/16" x 1" Flat Head Screws (3) and the two 5/16" x 1" Bolts (4) (only one side is shown).
With the help of a second person, hold the con- sole assembly near the Right Handrail (83) and the Left Handrail (not shown).
Connect the Upright Wire (87) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER. Remove the wire tie from the Upright Wire.
Connect the ground wire from the console as- sembly to the Console Ground Wire (52).
11 | Console | Console | |
| |||
Assembly | Wire |
| |
Console |
| 87 |
|
Wire |
|
|
|
87 |
|
|
|
Wire |
| Ground Wire |
|
Tie |
| 52 | |
4 |
|
| |
| 83 |
| |
3 |
|
| |
12.Set the console assembly on the Left and Right Handrails (82, 83). Be careful not to pinch any wires. Insert the excess Upright Wire (87) into the Right Handrail.
Attach the console assembly to the Crossbar (107) with six #8 x 3/4" Screws (1). Start all six
Screws, and then tighten them.
Attach the two Console Clamps (105) to the console assembly with four #8 x 1" Screws (53).
12 | Console Assembly |
| ||
|
| |||
| 87 |
|
|
|
|
|
| 105 | 82 |
|
|
| 53 |
|
| 83 |
| 107 |
|
| 1 | 1 | 1 | |
12
