If you purchase the optional chest pulse sensor (see page 18), follow the steps below to install the receiver included with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated Screw (78) and the Access Door (96).
2.Remove the paper from the adhesive pad on the back of the receiver (A). Hold the receiver so the small cylin- der is near the lower edge of the receiver and facing the Console (107) as shown. Firmly press the Receiver onto the indicated corner of the Access Door (96).
Connect the wire on the receiver to the indicated wire ex- tending from the Console.
3.Make sure that no wires are pinched. Reattach the Access Door (96) with the Screw (78). Discard the wires included with the receiver.
| 107 |
|
| Wire |
|
| A | Wire |
|
| |
96 |
| Cylinder |
|
| |
| 78 |
|
10
