5.Follow your progress with the display. See step 6 on page 12.
6.Measure your heart rate if desired. See step 7 on page 12.
7.Turn on the fan if desired. See step 8 on page 12.
8.When you are finished exercising, remove the key from the console.
See step 9 on page 12.
HOW TO USE A CROSS TRAINING PROGRAM
1.Insert the key into the console.
See HOW TO TURN ON THE POWER on page 11.
2.Select a cross training program.
To select
one of the four cross training pro-
grams, press the Professional Cross
Training
Programs button repeatedly. When a cross training program is selected, the display will show the word UPPER, LOWER, or TOTAL and the number of minutes that the program will last. In addition, the maximum incline setting of the program and the maximum speed setting of the program will flash in the display. A few seconds after a cross training program is selected, a profile of the speed settings of the program will scroll across the display.
3.Press the Start button to start the program.
A moment after the button is pressed, the treadmill will automatically adjust to the first speed and in- cline settings of the program. Hold the handrails and begin walking.
Each program is divided into 25, 30, or 45 one- minute segments. One speed setting and one in- cline setting are programmed for most segments. (Note: The same speed setting and/or incline setting may be programmed for consecutive segments.) During other segments, the console will prompt you to perform strength exercises.
During the program, the profile will show your progress. The flashing seg- ment of the
profile represents the current segment of the pro- gram. The height of the flashing segment indicates the speed setting for the current segment. At the end of each segment, a series of tones will sound and the next segment of the profile will begin to flash. If a different speed or incline setting is pro- grammed for the next segment, the speed or incline setting will flash in the display to alert you.
The program will continue in this way until the last segment of the profile flashes in the display and the last segment ends. The walking belt will then slow to a stop.
If the speed or incline setting for the current seg- ment is too high or too low, you can manually over- ride the setting by pressing the Speed and Incline buttons. Important: When the current segment of the program ends, the treadmill will automati- cally adjust to the speed and incline settings for the next segment.
14
