3.With the help of a second person, carefully tip the Uprights (82) down as shown. Note: It may be helpful to place a foot on one of the Wheels (95) as you tip the treadmill.
Attach each Extension Leg (103) with two Screws (101) and a Base Pad (52) as shown. Make sure that the Extension Legs are fully inserted into the Uprights (82); push down on the Uprights as you tighten the Screws.
Note: One replacement Base Pad (52) and Spacer (not shown) may be included. If a Base Pad becomes worn and needs to be replaced, use the replacement Base Pad. If a Thick Base Pad (97) needs to be replaced, use the replacement Base Pad with the Spacer.
With the help of a second person, carefully tip the Uprights (82) back to the upright position.
4.Place the Console Base (87) on the Handrails (85, 23). Make a loop with the indicated plastic tie and insert the two Wires (17) through the loop. Pull out just enough of the two Wires to connect them to the connectors in the Console Base, and then plug the Wires into the connec- tors. Important: Make sure that the Wires are fully in- serted. Tighten the loop and cut off the excess plastic tie.
WARNING: Do not disconnect or connect the Wires while the treadmill power cord is plugged in.
Refer to drawing 4b. Thread four Long Screws (79) into the Handrails (85, 23) and the Console Base (87). After all four Long Screws have been started, tighten the Screws until they are snug; do not overtighten the Screws.
Refer to drawing 2c. Tighten the four Handrail Bolts (89).
5.Remove the Lock Knob (105) from the Lock Pin (11).
Make sure that the Lock Pin Collar (14) and the Spring
(56)are on the Lock Pin as shown. Insert the Lock Pin into the Latch Bracket (77).
Tighten the Lock Knob (105) onto the Lock Pin (11).
Attach the Fan (108) to the left or right edge of the Console Base (87) near the cup holder as shown. Make sure that the clamp on the bottom of the Fan is on the Left or Right Handrail (23, 85) (see drawing 4b above).
3 | 97 |
|
|
|
|
|
|
| |
|
|
|
| 82 |
|
|
|
| 52 |
|
|
|
| 101 |
| 103 |
| 97 | |
82 | 52 |
|
|
|
|
|
|
| |
| 101 |
|
|
|
103 | 97 |
|
|
|
|
|
|
| |
| 95 |
|
|
|
4a |
|
|
|
|
85 |
|
|
| 87 |
|
| 17 |
| |
| Tie |
|
|
|
4b |
|
|
| 87 |
|
|
|
| |
85 |
|
|
|
|
|
|
|
| 23 |
| 79 |
|
| 79 |
|
|
|
| |
5 |
|
|
|
|
| 108 |
|
|
|
| 87 |
|
|
|
| 105 |
|
|
|
| 77 | 56 | 14 | 11 |
6.Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor, place a mat under the treadmill.
6
