ASSEMBLY
To hire an authorized service technician to assemble the treadmill, call
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included allen wrench | and your own phillips screwdriver | (with |
a shaft at least 6” long) and wire cutters | . |
|
Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag, check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly.
Extension Leg Nut | Star Washer | 1” Tek Screw | Latch Screw |
Console Bolt | Extension Leg Bolt |
1. Make sure that the power cord is unplugged. | 1 |
|
| |
|
|
| ||
With the help of a second person, carefully tip the |
|
| 84 | |
treadmill onto its left side as shown. Partially fold the |
|
| ||
|
|
| ||
Frame (58) so the treadmill is more stable. Do not fully |
|
|
| |
fold the Frame until the treadmill is completely as- | 65 |
|
| |
sembled. |
|
| ||
8 | 82 | 82 | ||
| ||||
|
|
| ||
Attach four Base Pads (82) (only two are shown) to the |
|
|
| |
base of the Uprights (84) with four 1” Tek Screws (83). |
|
|
| |
Insert an Extension Leg (89) into the base of the Uprights |
|
| 83 | |
|
|
| ||
(84) as shown. Hold two Extension Leg Nuts (67) in the |
|
| 67 | |
bottom of the Extension Leg. Next, insert two Extension |
| 89 | ||
Leg Bolts (65) with Star Washers (8) into the top of the |
|
| ||
Extension Leg, and firmly tighten the Extension Leg Bolts | 58 |
|
| |
into the Extension Leg Nuts. |
|
| ||
With the help of a second person, carefully tip the |
|
|
| |
treadmill onto its other side. Attach the other |
|
|
| |
Extension Leg (not shown) as described above. |
|
|
|
6
