ProForm PFTL71505.2

PROBLEM: The power turns off during use

SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see the drawing

above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for

five minutes, and then plug it back in.

c. Remove the key from the console. Reinsert the key into the console.

d. If the treadmill still will not run, please see the front cover of this manual.

PROBLEM: The console displays remain lit when you remove the key from the console

SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a

store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off

the demo mode, see THE INFORMATION MODE on page 22.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Remove the key from the console and UNPLUG THE

POWER CORD. With the help of a second person,

carefully tip the Upright (69) down. There may be two

Belly Pan Screws (115) in the bottom of the Belly Pan

(81). If there are, remove them. Note: A Phillips screw-

driver with a shaft at least 5 in. (13 cm) long is re-

quired. Then, raise the Uprights.

Remove the Belly Pan Screws (115) from the Hood

(1), and carefully pivot the Hood off.

Locate the Reed Switch (10) and the Magnet (18) on

the left side of the Pulley (17). Turn the Pulley until

the Magnet is aligned with the Reed Switch. Make

sure that the gap between the Magnet and the

Reed Switch is about 1/8 in. (3 mm). If necessary,

loosen the 3/4" Tek Screw (58), move the Reed

Switch slightly, and then retighten the Screw.

Reattach the Hood (not shown), and run the treadmill

for a few minutes to check for a correct speed read-

ing.

115

Top

View

1/8 in. 17

115