ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires your own phillips screw-

driver and rubber mallet .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1. With the help of a second person, carefully raise the

 

 

1

 

 

treadmill to the upright position as shown.

 

 

 

 

 

 

 

 

 

While a second person tips the treadmill to one side and holds it, insert one of the Extension Legs (102) into the treadmill as shown. Make sure that the Extension Leg is turned so the Base Pad (99) is on the bottom.

Next, tip the treadmill to the other side and insert the other Extension Leg (not shown) in the same way. Lower the side of the treadmill so that both Extension Legs

(102) are resting flat on the floor.

 

 

102

 

 

 

 

 

 

99

2. With the help of a second person, carefully lower the

2

 

 

treadmill frame and then tip the Uprights (69) down as

 

 

 

 

 

shown. Make sure that the Extension Legs (102) remain

 

 

 

in the Uprights.

 

 

 

Attach each Extension Leg (102) with two of the six 3/4”

 

99

 

 

 

 

Screws (100) as shown.

 

Frame

 

With the help of a second person, carefully tip the

 

 

69

Uprights (69) back to the vertical position.

 

 

 

69

 

100

Note: One replacement Base Pad (99) may be included.

 

102

 

 

Use the extra Base Pad if one becomes worn or needs to

99

100

 

be replaced.

 

 

102

 

 

 

 

3. Insert a Handrail Extension (66) into the post on the right

3

 

 

Upright (69) as shown; make sure that the indicated holes

 

 

 

76

 

are on top. Tap the Handrail Extension with a rubber mallet

 

81

to fully insert it. Attach the Handrail Extension with two 1/2”

 

Tab

 

67

Screws (67) as shown.

 

 

 

 

 

Holes

 

Identify the Right Foam Grip (75), which has a large cutout

Cutout

 

 

 

in the left side for the Pulse Bar (76). Slide the Right Foam

75

69

Grip as far as possible onto the post on the right Upright

 

 

Post

(69). (Note: It may be helpful to apply soapy water to the

66

Handrail Extension [66].) Make sure that the tab on the

 

 

Foam Grip is inserted into the Console Base (81).

 

 

6

Page 6
Image 6
ProForm PFTL99601 user manual Assembly, Driver and rubber mallet