We want to thank you for choosing an amplifier from Proson. We hope that it will bring you many hours of pleasure. Our amplifiers are suitable for both HiFi as well as Home Theatre.
This amplifier has a wide field of application, we describe the most com- mon ways to use it.
Using the amplifier as a subwoofer amplifier in
1.Make sure that the amplifier is turned off.
2.Remove the metal
3.Tweeter/midrange terminal is connected to the receiver.
4.Use a speaker cable to connect the tweeter/midrange terminal on the speaker to “Speaker Level Input” L and R on the amplifier.
5.Use a speaker cable between the bass terminal on the speaker to “Speaker Output” on the amplifier.
6.Make sure that the phase is correct, that you have connected + to + and – to
7.Turn on the amplifier and the receiver.
Using the amplifier as a subwoofer amplifier: (Using a RCA cable)
1.Make sure that the amplifier and the receiver is turned off.
2.Use a
3.Connect the subwoofer to “Speaker Output” on the amplifier.
4.Make sure that the switch is turned to “Low Pass”.
5.Make sure that the phase is correct, that you have connected + to + and – to
6.Turn on the amplifier and the receiver.
(Using speaker cables)
1.Make sure that the amplifier and the receiver is turned off.
2.Connect a speaker cable to Speaker Output on the receiver, R (Right) to “Speaker Level Input R” on the amplifier.
3.Connect a speaker cable to Speaker Output on the receiver, L(Left) to “Speaker Level Input L) on the amplifier.
4.Connect the subwoofer to “Speaker Output” on the amplifier.
5.Make sure that the switch on the amplifier is turned to “Low Pass”.
6.Make sure that the phase is correct, that you have connected + to + and – to
7.Turn on the amplifier and the receiver.
2
Use the amplifier as a full register amplifier (Using RCA cables)
1.Make sure that the amplifier and the receiver is turned off.
2.Connect a RCA cable from “Pre Out” on the receiver to “Line In” on the amplifier.
3.Connect a speaker cable from “Speaker Output” on the amplifier to the speaker.
4.Make sure that the switch is turned to “Full”
5.Make sure that the phase is correct, that you have connected + to + and – to
6.Turn on the amplifier and the receiver.
(Using speaker cables)
1.Make sure that the amplifier and the receiver is turned off.
2.Connect a speaker cable from Speaker Output Left and Right on the receiver to “Speaker Level input R/L” on the amplifier.
3.Connect a speaker cable from “Speaker Output” on the amplifier to the speaker.
4.Make sure that the switch is turned to “Full”
5.Make sure that the phase is correct, that you have connected + to + and – to
6.Turn on the amplifier and the receiver
Circuit breaker
STAND
3
