PSB Speakers Platinum Series Warranty Registration, Unpacking, Adjusting Rubber Levelers and Spikes (Tower and Monitor Speakers), Adjusting Rubber Bumpers , Wall Mounting S2 Surrounds

Congratulations on choosing PSB Platinum Series speakers. Please take the time to read the instructions in this guide, as

they will help you enjoy the full potential of your loudspeakers in any stereo or multichannel home theater application.

Warranty Registration

We recommend you take a few moments now to register your warranty, preferably on-line at

psbspeakers.com/w/Warranty.html or via the enclosed registration form so that we will be able to serve you better in the

future.

The packing materials of your PSB Platinum Series speakers are designed to protect them from damage during shipping.

Retain the packaging in case the need arises to transport the speakers in the future.

Attach the supplied spikes or rubber

levelers to the bottom of the speaker as

shown in the diagram at left. On carpets,

position the speakers and adjust spikes to

the desired height (higher for thicker carpet)

and hand tighten the knurled locknuts

against the bottom of the cabinet.

Adjusting Rubber Bumpers (For Center Channel Models)

Attach supplied rubber bumpers to the bottom of the

speaker as shown in the diagram. For positioning of

speakers on top of a smaller surface (ie. top of TV

cabinet) locate the bumpers on the bottom such that

they all touch and support the speaker on the smaller

surface. Bumpers across the rear of the cabinet can be

left off to tilt the speaker slightly upward if located on a

shelf below a screen. Bumpers across the front can be

left off to slightly tilt the speaker down if located above

a screen.

Attach supplied rubber bumpers to the lower rear panel of each speaker. Refer to the supplied template/instruction

sheet to accurately and securely position the mounting hardware on the wall.

Note:

The middle of the three mounting screws

should be screwed firmly into a wall stud. The outer two screws should then use an appropriate dry-wall mounting

fastener. If it is not possible to mount to a stud then proper drywall mounting anchors must be used. There are simple

expanding plastic sleeves commonly used for mounting fixtures to dry-wall. These are not adequate and must not be

used. Rather, choose one of the wide expanding, permanently captured style of wall anchors designed for mounting

heavier loads to dry-wall.

If you don't feel confident in such matters we strongly recommend that you have your dealer or a professional

contractor assist you in the mounting of your surround speakers. The installer is responsible for the correct selection

and use of mounting hardware (available through local hardware retailers) that will ensure the proper and safe wall-

mounting of the speakers.

Rubber Washer

Knurled Locknut

Rubber Leveler

Carpet Spike

Towe r Ba s e Optiona l: P S B P la tinum S ta nd (not s hown)