SPECIFICATION FOR DOMESTIC WATER HEATERS
Power Combustion,
Furnish and install TURBOPOWER® oil water heater(s) as manufactured by PVI Industries, L.L.C. of Fort Worth, Texas. Supply quantities and model numbers as indicated on the plumbing schedule.
Efficiency
The water heater will operate at a minimum of 83% thermal efficiency. The water heater will comply with paragraph 7.2.4.4, the thermal efficiency, the standby loss, and all other requirements of ASHRAE
Pressure Vessel and Heating Surfaces
The water heater will be constructed and stamped in accordance with Section IV, Part HLW of the ASME code.
The storage section of the water heater will be National Board Registered for a working pressure of ____ 125 psi
(standard) or ____ 150 psi and will be pressure tested at
heater will be National Board Registered for a working pressure of 150 psi and will be pressure tested at
The heat exchanger will be a firetube design with the combustion chamber and all heating surfaces completely
Tank Lining
The entire lining will:
be applied only after the tank is completely fabricated and all welding is completed.
be a thermoplastic polymer that is NSF 61 approved and consist of FDA compliant materials.
consist of multiple applications creating a continuous and nonporous barrier with no interruptions or discontinuities, particularly at the
be confirmed after all welding is completed to be 100%
The lined tank will not require anode rods and none will be used. Water heaters that use anode rods in a vessel that contains
Burner and Venting
Combustion will be provided by a
___ UL (standard) ___ FM ___ IRI ___ Other ______________________
Burner will be configured to accept ____ room air _____ direct inlet combustion air.
(continued)
PV 6113b 6/03 | 1 |