Connecting to Power Source

Fig. 3A

Fig. 3B

NOTE: Setting the index line to 1/4" on the ring means the cutting edge of the bit is exposed 1/4" below the base.

Before connecting tool to power source ALWAYS MAKE SURE SWITCH IS IN THE “OFF” POSITION. Also check that the power circuit is the same as that shown on specification plate of the router.

STARTING AND STOPPING THE MOTOR

Before starting the router, make sure that the bit is clear of the workpiece and foreign objects. Keep a firm grip on router to resist starting torque.

Start and stop the motor by setting the toggle switch (A) Fig. 4 to the “ON” or “OFF” position.

Fig. 4

To avoid personal injury or damage to finished work, always allow the motor to come to a COMPLETE STOP before setting it down.

Page 11

Image 11

PYLE Audio 100 instruction manual Connecting to Power Source, Starting and Stopping the Motor

Contents

Router Important Safety Instructions Table of Contents California Proposition Safety Guidelines Definitions General Safety Rules General Safety Rules Clear the Router BIT Area before starting motor Additional Specific Safety Rules Symbol Definition Extension Cord Selection Motor Operation Carton ContentsFunctional Description Attaching the Motor to the Router Base Adjusting Depth of CUT Starting and Stopping the Motor Connecting to Power Source Edge Guide Using the Router Templet Guides Troubleshooting Service Maintenance Warranty AccessoriesPage Canadian PORTER-CABLE Delta Service Centers