![LOCATION OF CONTROLS](/images/new-backgrounds/11928/119285x1.webp)
LOCATION OF CONTROLS
1 | Adjustable Dock Dial | 11 | Program/Memory/Alarm2 Button |
2 | iPod/iPhone Connector | 12 | Volume + Button |
3 | Speaker | 13 | Volume - Button |
4 | CD Compartment | 14 | Open CD Door Button |
5 | Power/Alarm Off Button | 15 | Remote Sensor |
6 | Function/Clock Adjust Button | 16 | Display |
7 | Play/Pause/Sync Button | 17 | DC In Jack |
8 | 18 | FM Antenna | |
9 | Skip+/Tune+ Button | 19 | |
10 | Stop/Memory+/Alarm1 Button |
|
|
- 4 -
CONNECTING THE UNIT TO POWER
Plug one end of the AC/DC adaptor into the
Backu-up Battery
Open the battery door located at the bottom of the unit, insert 2 pcs. ‘AAA’ size
In case of AC power outage or interrupted AC power, the current time, alarm time settings and the stored radio stations are preserved in the memory of the unit.
Important: When the unit is not use for 3 days or more and also the unit is not connect to AC power during that time, please remove the battery to avoid damage to the set from leakage of battery.
SETTING THE TIME
Before starting to set the time, make sure that the unit is in POWER OFF Mode .
If you have iPod (Except iPod Shuffle) or iPhone
1.) Dock in the iPod/iPhone on the 30 pins Connector
2.) Press the ‘PLAY/PAUSE/SYNC’ button for a few seconds until the display will show SYNC with flashing, then the unit will synchronize the time same as the iPod/iPhone’s automatically.
If you do not have any iPod/iPhone units
1.) Press and hold the ‘FUNC/CL ADJ’ button for a few seconds, the hour digit in the display will start flashing.
2.) Press the ‘TUNE+/SKIP+’ or
3.) When the correct hour is selected, press the ‘FUNC/CL.ADJ’ button again to enter the minute mode with minute digit flashing.
4.) Press the ‘TUNE+/SKIP+’ or
5.) When the correct time is selected, press the ‘FUNC/CL ADJ’ button to store the time in the memory.
SETTING THE ALARM TIME
Before starting to set the alarm time, make sure that the unit is in POWER OFF mode.
1.) Press the ‘MEM+/AL1’ or ‘MEM/AL2’ button once (You can also use the ‘AL1’ or ‘AL2’ button on the remote control) and the AL1 or AL2 icon will appear in the display.
2.) Press the ‘FUNC/CL. ADJ.’ button to select the alarm wake up source. You can choose buzzer, iPod/iPhone, Radio or CD.
3.) Press and hold the ‘MEM+/AL1’ or ‘MEM/AL2’ button for a few seconds, the alarm hour digit will begin flashing.
4.) Press the ‘TUNE+/SKIP+’ or
5.) When the desired alarm hour is selected, press the ‘MEM+/AL1’ or ‘MEM/AL2’ button again, the alarm minute digit will begin flashing.
6.) Press the ‘TUNE+/SKIP+’ or
7.) When the desired alarm time is selected, press the ‘MEM+/AL1’ or ‘MEM/AL2’ button again to confirm.
Note : If you choose iPod/iPhone or CD as the alarm wake up source, please make sure that you havehave the iPod/iPhone or CD in place.
- 5 -