PYLE Audio PLA1200, PLA2230, PLA-4120 manual Ch amp PLA-2230 PLA-2260

features and specifications

2 ch amp PLA-2230 • PLA-2260

crossover mode selector

input level controls

crossover frequency control

bass boost level selector bass boost level control

sub sonic control

low level input

high level input

AUX line outputs

power LED protection LED

power fuse power terminals speaker connectors

When used with normal, full range system, set this switch to "FULL" . If you wish to use the internal crossover to power a driver or specific frequency range, use the "LPF"or "HPF" FOR the "LOWPASS" OR HIGHPASS" settings.

Enables the matching of input levels to the output levels from head unit (or other signal source). The input sensitivity of adjustment ranges from 6V to 200mV.

When crossover mode selector is in HIGHPASS mode, this control sets the lower frequency limit for audio program sent to the speakers. When crossover mode selector is in LOWPASS mode, this control sets the upper frequency limit for audio program sent to the speakers.

The crossover is continuously variable adjustment from 40 t0 250 Hz. This selector switch permits the bass level an increase of 18dB.

This control permits adjustment of the bass level up to an increase of approximately up to 18dB.

When the sub sonic selector switch is in "ON" mode, this filter control permits continuously variable adjustment from 10 to 100Hz.

This amp features gold-plated RCA type jacks for high

impedance input. Use these with car stereo output which uses RCA type connector cables.

If your car stereo jacks RCA type output, use this adaptor to connect the high-low level input adaptor to connect the speaker output leads of car stereo and the RCA input jacks of amp.

This amp features gold-plated RCA jacks for AUX line outputs. Use these outputs. Use these for unlimited system expansion to the next CHOPPER. This indicator is illuminated in GREEN when power is applied.

This indicator is illuminated in RED when the built-in protection circuitry is actirated.

The fuse protects the amplifier and your car's electrical system from short circuit conditions.

Use these connectors to deliver power, ground, and remote turn-on control to the amplifier.

These terminals are 14K gold plated to guarantee high conductivity and minimum signal loss.

output power @ 14.4v DC, 1KHz

RMS Power @ 4 Ohms THD @ 4 Ohms RMS Power @ 2 Ohms THD @ 2 Ohms

Maximum Power Output bridged Power at 4 Output

frequency response input impedance

low level inputs input sensitivity low level inputs

S/N ration channel separation crossover filters low Pass high Pass

bass boost matching speaker impedance

stereo mode bridged mode

maximum current draw power supply voltage

dimensions (W x H x L) mm inches

PLA-2230		PLA-2260
200 Watts x 2		300 Watts x 2
00 Watts x 2		00 Watts x 2
00 Watts x 2		00 Watts x 2
00 Watts x 2		00 Watts x 2
1500 Watts x 2		2000 Watts x 2
3000 Watts x 1		4000 Watts x 1
	15 Hz-30 KHz
	10K Ohms
		6
	250mV
	>95dB
	>65dB
	40 Hz-250 Hz
	40 Hz-250 Hz
	0~ +18dB
	2-4 Ohms
	4-8 Ohms
00Ax2		00Ax2

14.4V DC Neg. Ground (10.5-16V)

270 x 36 x 432	270 x 36 x 532
10.63 x 1.42 x 17	10.63 x 1.42 x 21