PRECAUTIONS AND MAINTENANCE
.1.This unit is designed for negative ground operation only. The equipment can be used safely, if the negative terminal of the battery is connected to the vehicle metal work.
2.Do not use speakers of impedance less than 4 ohms; and allow the speaker wires to be shorted together when the unit is switched on.
Otherwise it may overload or burn out the power amplifier stage.
3.If the car interior is extremely hot, as after being parked in the sun, do not use the player until the car has been driven for a while to cool off the interior.
4.Take care of your tape cassette to preserve the quality of the recordings. Do not allow them to be exposed to direct sunlight. Store them in a place protected from dirt and dust and avoid handing with greasy or oily hands. Also, keep the away from magnets, and motors of the permanent magnet type.
5.It is not advisable to use cassette tapes longer than
6.The capstan and tape head should be cleaned about once every six months with a soft cloth or
This will serve to maintain the richness and clarity of sound, and prevent loss of volume. Do not use a screwdriver, or ferrous metal rod , in carrying out the above cleaning. See illustration.
7.A loosely wound cassette tape will get damaged. Prior to using such tape, tighten it in a manner as guided by Fig. 2.A carelessly would cassette tape will cause unnecessary pressure on the tape resulting in the cassette springing out while the tape is running .For prevention, rewind the tape through fast for warding or rewinding.
17.POWER BUTTON
Press it to turn on or off the unit.
18-19.DISC SELECTING BUTTONS
In CD changer mode, press the DISC + button to select the next disc and the DISC - button to select the preceding disc.
20.AMS BUTTON(Automatic Music Select System)
In tape mode, press AMS button to turn on the AUTOMATIC MUSIC SELECT SYSTEM. Then if you press FF or REW button, it allows you to skip forward or backward to the beginning of a particular selection.
Press AMS button again to cancel AMS mode.
22.APS BUTTON
Press BAND button to select the bands, then press APS button to indicate the frequencies of 6 stations that were stored into the band for
5 seconds each time.
Press APS button for more than 2 seconds to auto seek station on current band then auto write into the preset memories of 6 digital When the
23.LO/DX BUTTON
Press it for distance reception when you are located at the weak signal location. Depress it for stronger signal.
24.ST/MO BUTTON
Press it to select stereo or mono sound mode.
