System setting
2.Push [RIGHT] to enter the
3.Push [MAIN PAGE] to exit system setting.
Notes:three screen ratio modes, i, e, 16:9 WIDE, 4:3 PS, 4:3 L are available for your selection to enable different discs to match TV. the relationship between the video of disc and screen ratio mode are as follows:
Video of disc | normal | 4:3PS | 4:3LB | 16:9 |
4:3
16:916:9
System setting
once to move the high lighting band to "STEREO" item, then
push [ENTER].
3,Push [MAIN PAGE] to exit system setting page.
Example 3: Coaxial output
If the user use coaxial terminal to output audio signal, you need to set the audio output "SPDIF/RAW' or "SPDIF/PCM", you can operate following these procedures:
Push [SETUP] to enable TV screen display system setting menu picture, please firstly enter general setting
AUDIO SETUP
Example 2:Set sound mix output mode
1. Push [SETUP] to enable TV screen display system setting |
menu picture, push [DOWN] to move the high lighting band to the |
AUDIO OUT
OP MONO DUAL MONO DYNAMC PRO LOGIC LPCM OUTPUT
ANALOG
SPDIF/RAW
SPDIF/PCM
item "SPEAKER SETUP", push [ENTER], TV screen will display |
2. Push [RIGHT] to enter the |
want to set the sound mode to "STEREO", firstly push [DOWN]
MAIN PAGE
DYNAMC RANGE COMPRESSION
2.Push [RIGHT] to enter the
3.Push [MAIN PAGE] to exit system setting.
Special indications: if you are not going to use coaxial output audio signal, you need to set audio output to "ANALOG' output, so there will be no audio signal to set audio output to "ANALOG" output, so there will be no audio signal to be output in the mixchannel.
16 | 17 |
