How to use, Specifications | PYLE Audio PLVWH2

How to use

1.Turn on the audio/video equipment connected to the transmitter.

3. Adjust volume control on the left side. Do not cover the sensors while adjusting volumes.

2.Turn on the power switch for headphone.

4.Turn on the stereo switch for stereo effect. For Mono audio/video equipment, turn the switch to the mono position.

5.Receiving Positions

The headphone / Receiver receives audio signals omni-directionally and in line-of-sight within certain effective ranges.

For best reception, use th headphone. within 5 meters from the emitter of the transmitter.

*Infrared Wave-Lenght: 850mm

*Modulation: Frequency Modulation

*Carrier Frequency: L-ch ---- 2.3 MHz R-ch ---- 2.80 MHz

Transmitter:

*Input Voltage: 12 VDC +-2V

*Current: <80mA

*IF Frequency: L-ch --- 2.3 MHz +-15KHz R-ch --- 2.80 MHz +-15KHz

*Impedance: 10K ohm +-15%

*Auto. On Lever: Less Than 30 mV (input: 1KHz)

*Auto. Off Time: 120 Sec - 240 Sec

*Connecting Pin Wiring Source: (1) Ground (2) Left Ch (3) Right Ch.

(4)GND (5) +12V