HardwareList: Actual parts appearance and the quantity may differentwithillustrated.HardwareList:
4
4
H
I
J
K
4
4
Squarewasher
Longbolt
Wallanchor
Longbolt washer
Spacer
ID Description
1
2
A
3
B
C
1
2
4
2
4
4
Wallmount
Bracket
M4 mm×12 bolt
M4 mm×16 bolt
M5× mm16 bolt
M6×16mmbolt
M5×36mmbolt
M6×36mmbolt
Qty
D4
4
4
4
E
F
G
Safebolt
Afterdetermining the height of stand, follow the installation instructions in below
toinstall wall mount to different kinds of wall -wooden, concrete.
Usinga awl or nailto make where thenails arelocated,as shownas fig.2b.Distance
betweentwo nails for fixing wall mount must not less than 16”. Pre-drillthese holes
witha 5mm drill bit to at least 40mm in deep hole. Please makesure these holes are
leveland located at center.Use wall mount as a template to mark the location of other
threeholes and drill the same holes. Fix the wall mount to the wall with 4 long bolts(H)
andwashers(J).
Woodenwall:
Woodenwall:
-2- -7-A-F JGIHK
ID Description
Qty Fig 2b Fig 2c
Concretewall:
Usingthe wall mount as template to mark 4 holes location on the wall. Please make
surethese holes are level and at least 6” between any two lines. Pre-drillthese holes
witha 10mm drill bit to at least 50mm deep hole. Insert wall anchors(I) into each of
theseholes. Attach the wall mount to the wall using 4 long bolts(H) and washers(J).
Concretewall:
H
J
1
123
Balance-adjusting
Usingbalance-adjusting system on the plate, make sure whether wall plate is installed
balance.If not, then slide the wall plate let pointer level in the center position.
UP
UP