Remote Controller ________________________________________________________________

Loading batteries

Insert the two accessory 1.5V batteries, type “AA” (IEC R6), into the battery compartment in the back of the remote controller. Press the grooves on the battery compartment lid and slide it off. Insert the two batteries, taking care to match the +, - polarities correctly with the diagram in the case.

Replace the compartment lid.

About the Remote Controller

The remote controller can be used to control component from your listening position. Take special note of the following points: When operating the remote control, point it in the direction of the infrared signal receiving window on the player.

The operating range of the remote controller is within 30˚ to each side of the front of the player, within a distance of about 6m (about 20 feet) on an uninterrupted straight line (the remote controller will not operate if furniture or other obstacles are directly between the remote controller and the player). Note that in areas struck by direct sunlight or bright spotlights, the operating range of the remote control may be shortened, or it may fail to operate at all.

Press operating switches separately and firmly.

Replacing Batteries

When batteries become weak, the signal transmitting performance drops, and the remote controller will become unusable. In this case, replace the old batteries with new ones.

Since even batteries with new ones.

Depending on manufacturer, be sure to use only identical “A” (IEC R6) 1.5V type batteries.

Do not mix new batteries with already used batteries.

Use batteries designed to prevent leakage of the electrolyte inside.

Remote Controller _______________________________

1. Amplifier Standby

When this key is pressed during the remote standby state, the power of the main unit can be switched on/off.

2. Source Select

Press one of these keys as your desired source.

3. Surr. Sound

Press this key to select surround on or off.

4. Equalizer

Press this key to select inside EQ or outside EQ.

5. Band

When in tuner mode, press this key to select FM or AM radio broadcast.

6. Mute

Press this key to mute the sound, press it again to cancel the mute function.

7. ST/Mono

Press this key to alternate between Stereo and Mono mode when listen to FM broadcast.

8. Sound Modes keys

Press one of these keys as your desired sound mode.

9. Amplifier Display

Press this key to display the current state of sound field and the surround mode.

10. PTY Search

-PTY Search: In FM state, press this key, the current program type appears on the display, using TUNING +/- to select the program type you desire.

11. Auto/Manual

This key is used to select AUTO or MANUAL tuning for AM and FM stations. Press once to set to AUTO again for MANUAL.

12. Memory

Press it to store the broadcast station as a preset.

13. Station up/down

Press these keys to select a preset channel during the tuner mode.

14./

Press these buttons to select the previous/next track of the playback.

15. Balance

Press this key first then press the volume key to balance the speakers.

16. Tuning +/-

Tuner frequency up and down

17. Volume +/-

Press these keys to decrease or increase the volume.

1

3 2

4 5

6

9

10

17

4

Page 5
Image 5
PYLE Audio PT-680A manual Remote Controller