PYLE Audio PTAU34 manual Features And Controls, 1Blue LED Output Level Display

FEATURES AND CONTROLS

(1)Blue LED Output Level Display

(2)Power On/Off and LED Indicator

Main power switch, the indicator lights when the amplifier is turned on.

(3)USB 2.0 Input Interface with LED Indicator

Press to play the last song backward, press to play the next song forward, and press to play and/or pause the song. When the song is ceased from playing, it will be memorized to resume once the amplifier is reactivated and/or the USB input is selected again.

(4)1/4" PHONE Jack

Accepts headphones with 1/4" plug.

(5)MIC Volume Control

Lets you adjust the volume of connected MIC to the proper setting.

(6)MASTER Volume Control

Lets you control the overall volume level. It doesn't affect the volume of MIC.

(7)BALANCE Control

Lets you adjust the sound balance between the left and right of amplifier outputs.

(8)BASS and TREBLE Control

Allows you to boost or attenuate bass and treble for the desired sound.

(9)AUX 1/AUX 2/CD/USB Input Selector

Lets you select the desired input music source. When it is switched to AUX1, AUX2, or CD input while the USB is still on playing, the playing signal of USB continues, just it is not sent to the amplifier's output.

(10)Switchable MIC PAGER and MIXING Modes

Set to PAGER, the signal from AUX 1/AUX 2/CD will be attenuated BY -12dB and the signal from MIC will override to page (Auto Talkover), it is good for paging system. Set to MIXING, the signals from

AUX 1/AUX 2/CD and MIC will be existed at the same time, it acts like playing at KARAOKE event.

(11)1/4" MIC Input Jack

Lets you connect a microphone with a 1/4" plug.

(12)AUX 1/AUX 2/CD RCA Inputs

Lets you connect most high level audio sources such as CD player, tape deck, tuner, camcorder, or VCR.

(13)REC RCA Output

Lets you connect the amplifier to a tape deck for recording.

(14)Push Type Speaker Terminal

Lets you easily connect speaker wires directly to the amplifier. The speaker impedance can be ranged from 4 to 8 Ohms for the general stereo output. The total speaker impedance must be at least 4-Ohm per channel at stereo mode.

(15)110/220 Voltage Selector

This amplifier has selectable input voltage from 110V/60Hz (the standard in USA and CANADA) to 220V/50Hz (for EUROPEAN operation). Please make sure the switch is in the proper position before operating, otherwise, the severe damage will be incurred and not covered by the warranty.

(16)Replaceable Power Fuse

The amplifier uses a fuse for protection against surges and short circuit. If the amplifier suddenly turns off and will not turn on, check the fuse and if necessary replace it with a 1.5-amp, 250-volt, fast-acting, 5x20mm fuse (not supplied).

3 - Pyle Pro PTAU34 Manual