Valet Mode
Valet mode can be entered and exited by performing the Remote Valet command or manually using the vehicle key and the control button. When entered, the convenience features still operate normally.
Use the following steps to manually enter and exit Valet Mode:
1.Turn the ignition switch On and then Off
2.Immediately press and release the control button once
3.The control center LED turns On when entering and Off when exiting.
Power Save
To reduce power consumption the control center status LED modifies its output if the vehicle is parked for an extended period. If Locked the flashing is reduced after 24 hours. When Valet mode is On the LED turns off after 1 hour and resets each time the ignition is turned off.
Power Save extends battery life by turning Paging Off after 72 hours if the remote control is not used during this period. Just press any button to resume system monitoring. Power Save 2 is for maximum battery life and will monitor the system only when remote start has been acti- vated. See “Page Mode*” on page 17 .
Rapid Resume
If power is ever disconnected by a mechanic or thief, the system will resume the state it was in at the time of disconnection, when power is reconnected.
Automatic Remote Updates
The system sends a silent message to all remote controls after any major action has occurred. When the remote receives this message it updates the Lock status.
26 | © 2011 Directed Electronics. All rights reserved. |
