2 – QLE2360/2362
Specifications
2-4 PX2454601-00 C
Q
If the information displayed is not correct and you have checked the QLE2360/2362
HBA’s configuration, see section3 for troubleshooting information.
2.2.1
Installation Help
If your system has an IDE hard disk, it may be assigned device number 80, which
is the boot device. If your system does not have an IDE hard disk, a parallel SCSI
host bus adapter, or a RAID adapter, the first bootable FC hard disk configured (the
one with the lowest ID) is assigned device number 80 and becomes the boot device.
The QLE2360/2362 HBA BIOS must be enabled if the boot device is connected to
the QLE2360/2362 HBA.
If you have a selectable boot BIOS and want to boot to an FC hard disk, set the
motherboard BIOS parameters to None or Not Installed. The ROM BIOS on the
QLE2360/2362 HBA automatically configures the FC peripherals.
Some new system BIOS’ support selectable boot, which supersedes the
QLE2360/2362 HBA BIOS selectable boot setting. Select the QLE2360/2362 HBA
FC hard disk in the system BIOS to boot from an FC hard disk attached to the
QLE2360/2362 HBA.
2.3
Specifications
Table2-1 below defines the QLE2360/2362 specifications.
Table 2-1. HBA Operating Environment and Specifications
Host Bus Interface Specifications
Bus interface 2.5 GHz PCI Express x4
Memory 1-MB SRAM per port, 1-MB flash, and 4-Kb NVRAM
Compliance PCI Express Base Specification rev. 1.0a, PCI Express Card
Electromechanical Specification rev. 1.0, PCI Local Bus
Specification rev. 2.3, PCI Bus Power Management Interface
Specification revision. 1.1