6 | Basic Operation Instructions | Dolphin |
MAGNETIC KEY LOCK SYSTEM
1.To arm the locking system, hold the magnetic key on or near the key symbol on the Dolphin front panel. See figure 1. The system will beep and automatically power itself down. No LEDs should be lit.
2.To turn the power chair back on, press the On/Off Switch. The system will power on, but the locking system needs to be disarmed before normal operation can occur. The key symbol will flash, indicating that the system should be disarmed.
3.To disarm the lock, put the magnetic key on or near the key symbol. The LED will stop flashing, and normal operation may resume. If the locking system is not disarmed within one minute, the Dolphin will shut itself off.
JOYSTICK OONAPU
If the power chair is powered up while the joystick is not in the neutral position, the System Status LED will flash for as long as the condition persists up to a maximum of five seconds. After five seconds, a Fault Flash Code is signaled on the System Status LED, and the Remote Status LED will flash. To clear the fault, power down, put the joystick in neutral, and power the system back on.
DRIVE PROGRAM SELECTION
The Dolphin can control up to five drive programs. Drive Program 1 is configured as the slowest, and Drive Program 5 is configured as the fastest. To select the preferred drive program, press the Drive Program Select Switch. The selected drive program will be displayed on the
