Quantum INFMANU4169 manual To remove the SFR, Swing-Away Footrest SFR Foot Plate Length

	I V . C O M F O R T A D J U S T M E N T S
To remove the SFR:
1.	Move the SFR to the side.
NOTE: If your wheelchair is equipped with the ultra
hemi option, the SFR must be facing forward and not
swung to the side for removal.
2.	Pull the SFR up. See figure 19.
3.	Repeat for the other side if necessary.
Swing-Away Footrest (SFR) Foot Plate Length
You can change the SFR foot plate length between 7.5-
12.5 in. (19.05-31.75 cm) in 1-in. (2.54-cm) incre-
ments when equipped with direct mount foot plates and
12.5-14.75 in. (31.75-37.47 cm) in 1-in. (2.54-cm)
increments when equipped with extensions. This		Figure 19. SFR Removal
length is measured from the SFR foot plate to the top
of the SFR. See figure 20 or 21.
To change the SFR foot plate length:
1.	Remove the screw(s) from the SFR.
2.	Adjust the foot plate to the desired length.
3.	Reinstall the screw(s) into the SFR.
4.	Repeat for the other side.
Elevating Leg Rest (ELR) Foot Plate Length
You can change the ELR foot plate length between
12.5-14.75 in. (31.75-37.47 cm). This length is mea-
sured from the ELR foot plate to the top of the ELR.		SCREW
See figure 22.
To change the ELR foot plate length:		Figure 20. SFR Foot Plate Adjustment
1.	Loosen the screws on the back of the ELR.
2.	Adjust the foot plate to the desired length.
3.	Tighten the screws on the back of the ELR.
4.	Repeat the procedure for the other side.

WARNING! The footrests should be at least 2 in. (5 cm) from the ground at all times to ensure ground clearance from obstacles encountered in every day

use. Inadequate ground clearance that
can cause the wheelchair to stop	SCREWS
suddently and tip forward.

Figure 21. SFR Foot Plate Adjustment

Litestream Junior www.pridemobility.com 23