Quatech DSP-200/300 5 Windows NT

5 Windows NT

To allow easy configuration of the DSP-200/300 the Quatech Device Manager for Windows NT

has been written for the hardware. This configuration utility supports the DSP-200/300 only in

block addressing mode.

To begin the installation, open Windows Explorer and search for the ‘Setup.exe’ command to

install the Quatech Device Manager. <See following Windows Explorer figure.> (D:\Serial Port

Adapters\Drivers\Windows NT 4.0 for PCI, PCMCIA,ISA). Once the installation is complete an

icon will be placed on the desktop.

Windows NT Explorer

Windows NT 5-2

Contents

Main Warranty Information i Quatech, Inc. Declaration of Conformity Standards to which DSP-200/300 Specifications DOS/Windows 3.x Windows 95/98/Millennium (ME) Windows 2000 Windows NT 1. Introduction Page 2. DOS/Windows 3.x 2.1 DSP-200/300 Client Driver for DOS 2.1.1 Client Driver Installation 2.1.2 Command Line Options Page Page 2.1.3 Common Problems 2.2 DSP-200/300 Enabler for DOS 2.2.1 Command Line Options Page 2.2.2 Common Problems Page Page 3. Windows 95/98/Millennium (ME) 3.1 Installing a DSP-200/300 Under Windows 95/98/ME 3.2 DSP-200/300 Resource Settings in Windows 95/98/ME 3.2.1Viewing Resource Settings with Device Manager 3.2.2Changing Resource Settings with Device Manager Page 3-5 DSP-200/300 3.3 Frequently Asked Questions Page 4 Windows 2000 4.1 Installing a DSP-200/300 Under Windows 2000. Page Page 4.2 DSP-200/300 Resource Settings in Windows 2000 4.2.1 Viewing Resource Settings with Device Manager 4.2.2 Changing Resource Settings with Device Manager Page Page Page Page Windows 2000 4-12 Page Page Page 5 Windows NT 5.1 Installing DSP-200/300 Page Page Page 6. Hardware Information 6.1 Auxiliary Channel Configuration 6.1.1 Auxiliary Channel: RTS-CTS Handshaking. 6.1.2 Auxiliary Channel: Handshaking Disabled. 6.2 Half Duplex Operation + - + - 3 Options: Page 6.3 Termination Resistors Page 7. External Connections