2.1 “Power On” Indicator
Power On indicator illuminates when utility power’s condition is normal.
2.2 “BACKUP” indicator
The indicator illuminates when the power is supplied from the batteries.
2.3 “Battery Fault” Indicator
This illuminates indicating weak battery. Recharge the battery for at least four hours. If after recharging this still illuminates, replace the battery by following the instructions in the manual.(You can plug out then check battery)
2.4 Power Switch
Can be used as the master on/off switch of your equipment by leaving your equipment connected to UPS and switched on.
2.5 UPS Outlets
Provide instantaneous
2.6 Bypass Power Sag Outlets
Provides bypass power sag protection to your equipment. Prevent power problems traveling through your system via unprotected peripherals.
2.7 Circuit Breaker Protection
Serves as an overload and fault protection. This is a critical component of the advanced UPS
2.8 “Phone Jack” Communications Ports
Telecom transfer ports provide users to extend the applications.
●Caution: To reduce the risk of fire, use only No. 26AWG or larger telecommunication line cord.
2.9 communication function
Provide
5
