setting MIC sensitivity to Auto, we also recommend setting the MIC to Hi (high) for conference recording, while we recommend a setting of Lo (low) for dictation recording.
7.Press SET/DISP when the desired microphone sensitivity flashes to confirm it. VOX appears and either On or OFF flashes.
8.Repeatedly press VOL+/VOL– to turn VOX on or off.9.Press SET/DISP when the desired setting flashes to confirm it. BEEP appears and either On or OFF flashes.
10.Repeatedly press VOL+/VOL– to turn the button confirmation tone on or off.11.Press SET/DISP to confirm the setting and resume normal operation.RECORDING
Voice Activated
To record, you can use either the internal microphone or you can plug an external microphone into the MIC jack on the top of the recorder.
For the best results, place the recorder 5 in. to 3.3 ft (13 cm to 1 m) from the audio source. To find the optimum distance between the recording source and the recorder, experiment with various distances. Ô
If you enabled
Manual
1.Select a folder (See “Programming the Recorder”) and press REC/STOP to start recording. The current date and time appear briefly and are recorded as the date and time stamp for the current message.
REC flashes and the current message number and elapsed recording time appear.2.To view the available recording time left in the folder, hold down SET/DISP. REMAIN appears and the remaining recording time appears. Release SET/ DISP to resume normal recording.
3.Press REC/STOP again to stop manual recording.MARKING AN INDEX
DURING RECORDING
Indexes may be added to the recorded messages so that you can search and listen to specific sections of a message easily. Up
To mark an index, press MODE/INDEX when a message is being recorded. INDEX, the index number and the total number of indexes in the message appear briefly. (01/
05indicates index one of five, with 1 beingthe current index number and 5 being the total number of the indexes.) ÔPLAYING BACK MESSAGES
When the recorder is in recorder mode:1. | Rotate | up or down to scroll |
| through the messages until the desired | |
| number appears. Various information of | |
| the message will be shown and | |
| updated automatically. | |
2. | Press | to start playback. g |
| flashes. The date and the time stamp | |
| appear briefly. |
|
3.Press VOL+/VOL– to increase or decrease playback volume. The playback volume setting appears briefly.
4.To view a messages remaining playback time, hold down SET/DISP during playback. REMAIN and the remaining time appear. Release SET/ DISP to resume normal playback.
5. To pause playback, press . To resume press again.6.The recorder automatically stops at the end of each message. To stop playback
| sooner, press |
| . |
|
| ||
REWINDING |
|
| |
1. | Repeatedly rotate |
| up or |
| down until the desired message number | ||
| appears. |
|
|
2. | Press | to listen to the | |
| message. |
|
|
3. | Rotate or hold down | up or | |
| down to rewind or | ||
4.When the recorder reaches the end of a message while
When the recorder reaches the beginning of a message while rewinding, the recorder stops.
LOCATING AN INDEX
IN A MESSAGE
1. | Repeatedly rotate | up or |
| down until the desired message number | |
| appears. |
|
2. | Press | to listen to the |
| message. |
|
Specifications
Recording Medium..................... | ||
Recording Time .................................. | 51 minutes (SP), | |
|
| 68 minutes (EP), 90 minutes (LP) |
Frequency Range | ................. | |
Speaker ............................................... | 23mm diameter | |
Maximum Power ............................................. | 100mW | |
Earphone Jack ....................... | 3.5mm diameter, 8 ohm | |
Microphone Jack .. | ||
Power Requirement ................ | AAA size 1.5V alkaline | |
|
| battery ⋅ 2 |
Battery Life ........ | about 40 hours continuous recording | |
|
| 5 hour continuous playback |
Dimensions ............................ | 111/16 ⋅ 41/8 ⋅ 9/16 inch | |
|
| (44 ⋅ 105 ⋅ 15 mm) |
Weight ........................... | 1.5 oz (43g) without batteries | |
Accessories ......................................... | Carrying pouch | |
Specifications are typical; individual units might vary. Specifications are subject to change and improvement without notice.
Ô NOTE Ô
Voice Activated
•For low microphone sensitivity setting, suggest recording distance of about 5 in.
(13 cm). For high microphone sensitivity setting, suggest recording distance of about 3.3 feet (1 m). When in auto microphone sensitivity setting, you can obtain the best recording result within a larger distance range (around 5
•If the recorder does not detect sound for about 2 seconds during recording, the recorder stops, and REC and VOX stop flashing.
•When you begin recording in the selected folder, the recorder assigns a number to your message and the number appears. Message numbers are sequentially assigned from 01– 99.
•When the number of stored messages in a folder reaches 99, FULL appears when you press REC/STOP. Continue recording in the other folder. If the recording time in all folders is used up, you cannot record until you erase some messages. See “Erasing Messages” on Page 4.
Marking an Index During Recording
•When there are already 99 indexes in the current folder and MODE/INDEX is pressed during recording, FULL appears.
•When the recorder has reached full recording capacity and REC is pressed, FULL appears. You may erase some of the messages to free up recording capacity.
•When recording capacity is used up during recording, FULL appears and recording stop automatically
3