Setup 
Connecting the Microphone
1.Press the tab on the side of the supplied microphone’s plug and insert the plug into the MIC jack on the front of the transceiver. Be sure the tab is aligned with the jack’s notch.
Notch
Tab
2.Slide the microphone onto the microphone holder.
To disconnect the microphone from the transceiver, press the tab on the side of the plug. Then pull out the plug.
Caution: To avoid damaging the microphone, never pull on the microphone cable.
Connecting an External Speaker
Your transceiver also can be connected to an external CB speaker (not supplied).
Note: When you connect an external speaker, the CB’s internal speaker disconnects.
The external speaker you use with the transceiver should have an impedance of 8 ohms and be able to handle 3 to 10 watts of power. The speaker cable must have a 1/8
To connect the external speaker to the transceiver, insert the speaker cable’s plug into the EXT SPEAKER jack on the back of the CB.
7
